|
MT-16X2-2 (3) Water Controller
|
|
|
Micro Touch pioneered the use of microprocessor controls to regulate water injection on exhaust systems. The MT-16X2 is a state-of-the-art controller offering the adjustability racers and high-performance riders need for maximum performance. The unit installs easily and senses engine RPM with an inductive pickup wire. This unit is available in 2 or 3 cylinder versions. Choose from 16 different RPM settings for both "Water On" and "Water Off" to control water injected into one solenoid. Works great with all popular exhaust systems to find "hidden" power.
|
|
|
|
|
|
|
Wire Colors:
• Red with Fuse to 12v (+) on Battery or Tether Cord Ignition Power
• Black Wire to Ground (-) on Battery or suitable Ground
• Yellow Wire - Senses Engine RPM from Spark Plug Wires
Wrap around Each Plug Wire 3 Turns around - Then Tape!
• Gray Wire with Red - Black Wires - Water Injection Solenoid
|
|
|
Note
Keep Watercontroller a few inches away from ignition coil or plug wires.
Remember to keep Dielectric Grease on the fuse and jumper pins at ALL TIMES!!!
Wrap electrical tape around Watercontroller and pins after settings are made and grease is installed!
|
|
|
MT-16X2-2 (2 Cylinder Version)
|
$125.00
|
|
MT-16X2-3 (3 Cylinder Version)
|
$125.00
|
